Assembling the font axle for my fj45 project truck. Its parts and pieces from many different toyotas so this question might be difficult to answer but giving it a shot. I need to know the diameter of the front wheel studs (smooth area) just above the threads. (see pic)
I'm assembling the front rotors to the wheel hubs. These are the later land cruiser 60/62 or mini-truck type. rotors have 8 holes. two smaller holes for bolts. six larger holes for wheel studs. (see pic for type of rotor) wheel studs go through the rotor and are pressed into the wheel hubs from the back side of the rotor/hub.
I'm concerned the studs I have may be too big in daimeter. On the stud, I'm measuring 0.554" in diameter to the smooth area just past the threads and .570 diameter at the knurl. The knurl may be ok in diameter but the smooth area is not going to go easily through the wheel hub. BTW, rotor hole diameter for studs seem fine. No problem there.
I'm measureing .535 on the hole size in the wheel hub. I'm concerned that pressing a stud of .554 through that size hole will result in something bad.
These are aftermarket (Dorman) studs. Number cast on actual stud is 264. Full Part number I believe is 6102641. Alternate parts listed as "Alternate/OEM Part Number(s): 610264, 9094202044, 9094202053, 98484, 984841"
Info listed as "Serrated Stud; Thread; M12-1.5; Knurl Dia.: 14.46mm; Length: 52.5mm; Shoulder Length: 25mm".
Anyone used these studs?
Anyone have measurements from an OEM stud?
Are there any differences between Land Crusier 60/62 or mini truck front wheel studs?
I'm assembling the front rotors to the wheel hubs. These are the later land cruiser 60/62 or mini-truck type. rotors have 8 holes. two smaller holes for bolts. six larger holes for wheel studs. (see pic for type of rotor) wheel studs go through the rotor and are pressed into the wheel hubs from the back side of the rotor/hub.
I'm concerned the studs I have may be too big in daimeter. On the stud, I'm measuring 0.554" in diameter to the smooth area just past the threads and .570 diameter at the knurl. The knurl may be ok in diameter but the smooth area is not going to go easily through the wheel hub. BTW, rotor hole diameter for studs seem fine. No problem there.
I'm measureing .535 on the hole size in the wheel hub. I'm concerned that pressing a stud of .554 through that size hole will result in something bad.
These are aftermarket (Dorman) studs. Number cast on actual stud is 264. Full Part number I believe is 6102641. Alternate parts listed as "Alternate/OEM Part Number(s): 610264, 9094202044, 9094202053, 98484, 984841"
Info listed as "Serrated Stud; Thread; M12-1.5; Knurl Dia.: 14.46mm; Length: 52.5mm; Shoulder Length: 25mm".
Anyone used these studs?
Anyone have measurements from an OEM stud?
Are there any differences between Land Crusier 60/62 or mini truck front wheel studs?