Question for the Sniper crew - MAP at idle?

Joined
Nov 29, 2020
Messages
500
Location
Wausau WI
Just working through my setup, and I did just have a distributor sensor go wonky, so verifying other bits.

What are you typically seeing for kPa at idle for the MAP sensor?
 

GA Architect

SILVER Star
Joined
Feb 14, 2014
Messages
3,661
Location
Woodstock, GA
Here are a couple of pics after about and hour or so of driving this morning.

F71245D4-4308-4A3C-9200-9FB146801953.jpeg

72954B2C-B53F-4048-80E0-A08B94CAB9E3.jpeg
 
Joined
Nov 29, 2020
Messages
500
Location
Wausau WI
Back in biz'ness...I must've bumped the distributor a smidge when I was snugging it down. It was off from TDC, so timing was close enough to run but advanced, hence the weird vacuum readings from expected. Still need to put the actual distributor curve in (got waylaid there with the dizzy failure), but looking good again. It does seem to like 9* more than than book 7*base, but not unexpected.

Volts are low since no regulator...hopefully Monday.

To set the tach, just go to the main menu => Monitor => Channel Scaling. I set mine to a max display at 5k with redline at 4k, and a lower limit for the idle at 650.

5k worked better, if you set the max for 4k, the marks go 1, 2, 2, 3, 4 😆 🤔

PXL_20210911_212504353.MP.jpg
PXL_20210911_212617996.MP.jpg
PXL_20210911_212624447.MP.jpg
 
Last edited:

Users who are viewing this thread

Top Bottom