I’m guessing someone out there has pulled the motor/tranny as one to get at the frame To paint. Was thinking of just getting some 4x4’s etc and building a little cradle to set it on in the garage until it’s ready for paint and to go back in? Just want to make sure I don’t set it down wrong and tweak something etc. prob way over thinking it to be honest.
sequestion is hoist attachment points on the block? Any suggestions?
And yes, I just glossed over the fact (even in my own head) that I’m down the rabbit hole and pulling the entire truck apart... figure I’m pulling the springs off anyway for a 2” lift and replacing the motor mounts so it’s basically already there.
thanms
sequestion is hoist attachment points on the block? Any suggestions?
And yes, I just glossed over the fact (even in my own head) that I’m down the rabbit hole and pulling the entire truck apart... figure I’m pulling the springs off anyway for a 2” lift and replacing the motor mounts so it’s basically already there.
thanms