I am using the knuckle rebuild technique were you remove the lower control arm/bearing cap then lift the knuckle off. Then take the bearing off the upper bearing cap without removing the cap.
In the videos showing this done the bearing just slid off the cap.. but on mine it was very tight.
Can anyone recommend a bearing puller that will fit inside the knuckle to pull the knuckle bearing off the cap ?
Thanks !
In the videos showing this done the bearing just slid off the cap.. but on mine it was very tight.
Can anyone recommend a bearing puller that will fit inside the knuckle to pull the knuckle bearing off the cap ?
Thanks !