Wanted PTO winch (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

;) give me the curv, but i'm pretty sure, it is not important, metal channel will bend when you put the screw :)
 
Update: found some malleable
DSC04273.JPG
DSC04274.JPG
off the shelf wedges, I would just have to make inserts to get the hole down to 1/2". Any comments? price would probably be cut in half of the fabbed ones. John
 
:clap::clap:

Don’t need any, but that sure is cool John.
 
Count me in
JP
 
In as well.
 
190121082508430690.jpg.html
pilow block...i've a old one completly rebuild if need, price on demand

mini_190121082508430690.jpg

 
No it has not. The commitments did not add up, Those off the shelf ones were not close to being right. Measurements are on this thread if anyone can source them reasonably priced. Thanks for the interest all of you. John


Okay at that point I'll pull out regardless. Have a few sets of the small ones already. The upper ones I have enough for all I plan on using. The lower ones are optional.
 

Users who are viewing this thread

Back
Top Bottom