I guess a lot of the PTO's were made for the 3-speed trans. I have a 4-speed. So the drive shaft is 3" too short. No worries. While I was at it I tore apart the pillow block body. That was because it wouldn't turn. What I found out was,
Still available from Toyota:
Bearing
Snap ring (holds bearing in place)
Large dust seal (made of felt)
Dust seal retainer
Not available anywhere I could find:
Small dust seal
Large washer.
Here are some pics that shows what is where. Oh, and how I lengthened the PTO drive shaft.
Still available from Toyota:
Bearing
Snap ring (holds bearing in place)
Large dust seal (made of felt)
Dust seal retainer
Not available anywhere I could find:
Small dust seal
Large washer.
Here are some pics that shows what is where. Oh, and how I lengthened the PTO drive shaft.