PTO HELP needed

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 17, 2003
Threads
43
Messages
187
I bought a PTO, driveshaft and winch from Milesstarkey( if u read this u could probaly help me) now everything bolts up except there are 2 idler bearings on the driveshaft. I dont know where they would bolt up to. unless im missing brakets or something, I would really appreciate it if U guys can answer before monday, because my shop is 1 hour away and NO INTERNET soo cant see replies. if noone knows where they go ill guess ill make my own brackets.

Thanks, John.
 
Yes, the PTO idler bearings require a bracket to the frame. The single "eye" in the bearing housing is installed in a vertical rather than a horizontal orientation. There should be captive nuts on the frame rails in the vicinity of the idler bearings. Those captive nuts would be where the brackets bolt to.
I'm installing a PTO from an HJ61 in my BJ60 and I've had to get the shaft modified (eliminate a "U" joint) to suite the way it works on the BJ60 since the HJ61 uses two bearings and the BJ60 uses only one.
 
mine also uses 2 bearings, and I had a new driveshaft made, The shoft doesnt come close tot he frame to bolt up, until u get to where the front crossmember is. the old saft doesnt come close either
 
I went out and took some photos of my PTO shaft on my BJ74...I hope they help you.

This shot is of the two bearings on the PTO shaft: (sorry about the dirt :) )
PTO_shaft_bearings.jpg


This shot is a closer photo of the second bearing closer to the winch. Tried to shoot a photo of how the bracket bolts onto the frame.
PTO_bearing_2.jpg
 
Ok. thanks I see how it works now. I guess monday ill fabricate a bracket out of some C-Channel or something. Thanks again, u guys just saved me some time, I was planning on making a bracket from the skidplate to the frame and mount the bearings almost horizontaly.

Thanks
 
Here is how my '71 (like your '70) FJ40 pillowblock mounts to the bracket that comes off the front frame rail. Note that the pillowblock fits up inside the bracket with the crossbolt on the underside. The view is from behind.
pillowblockmount1.webp
 
Im not going to use the pillow block. just the 2 carrier bearings on the long shaft. plus the driveshaft is already built and he would have to make a new short shaft and put another bearing on it. Thanks anyway
 
Back
Top Bottom