PSA RockAuto "Wells" 60/62-Series Distributor Cap Incorrect - Wrong Vent Ports

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 21, 2012
Threads
36
Messages
785
Location
Rhode Island USA
I was doing a tune-up on my 62, and ended up purchasing some of the components through Rock Auto. I bought the only distributor cap they had in stock - the "Wells" brand. The picture shows the correct cap, but the actual part they send is not the same. It fits on the distributor and works, but it does not have right size ports for the vent hoses. It has little covers over the vents, but if you pull the covers off, the ports are too small for the vent hoses.

I ended up ordering the OEM cap and had it shipped to my local dealer for about $25, barely $10 more than I paid for the Rock Auto cap. Skip the grief, and just go OEM for this component.
 
I was doing a tune-up on my 62, and ended up purchasing some of the components through Rock Auto. I bought the only distributor cap they had in stock - the "Wells" brand. The picture shows the correct cap, but the actual part they send is not the same. It fits on the distributor and works, but it does not have right size ports for the vent hoses. It has little covers over the vents, but if you pull the covers off, the ports are too small for the vent hoses.

I ended up ordering the OEM cap and had it shipped to my local dealer for about $25, barely $10 more than I paid for the Rock Auto cap. Skip the grief, and just go OEM for this component.

Learned about 3 decades ago to only go with OEM for ignition components.
 
Learned about 3 decades ago to only go with OEM for ignition components.
And only Aisin fan clutches. :)


I have only purchsed from RockAuto twice. Both parts turned out to be junk and their lengthy, complicated to the point of impossible return process and the complete denial of any possibility ever speaking to a human (even when I attempted to contact the corporate offices via normal channels) convinced me to never give then a third chance.


Mark...
 
Last edited:
^THIS!!!^
Did the RA turn signal switch and it was toast in a couple months. I'll pay for OEM before losing any more money with them. Some may have good success, I have not been so fortunate.
Good Luck!
 
I was doing a tune-up on my 62, and ended up purchasing some of the components through Rock Auto. I bought the only distributor cap they had in stock - the "Wells" brand. The picture shows the correct cap, but the actual part they send is not the same. It fits on the distributor and works, but it does not have right size ports for the vent hoses. It has little covers over the vents, but if you pull the covers off, the ports are too small for the vent hoses.

I ended up ordering the OEM cap and had it shipped to my local dealer for about $25, barely $10 more than I paid for the Rock Auto cap. Skip the grief, and just go OEM for this component.

No reason to buy junk when OEM is still available online or from your local Toyota dealership parts department.
 
Back
Top Bottom