Power steering “inlet” hose (1 Viewer)

[UZJ100LC]

Hi everyone,
I’m looking for hose #62 in this diagram from SOR. It goes from the steering box of my ‘83 to the hardline near the radiator. SOR is calling it the inlet hose. It’s 3/8 ID, can I just use regular return line from NAPA for this or does it have to be high pressure line? The hose I took off is so hard and crusty I can’t tell if it was just a regular power steering return line or not.

Thank you.

 

[OSS]

All the plumbing downhill of the steering gearbox is low pressure. Any hose that’s rated for power steering return (ATF) that’s the correct ID will work.

 

[UZJ100LC]

All the plumbing downhill of the steering gearbox is low pressure. Any hose that’s rated for power steering return (ATF) that’s the correct ID will work.

That’s what I figured, these weird clamps were just throwing me off. Thank you OSS saving me once again.

 

[ToyotaMatt]

That’s what I figured, these weird clamps were just throwing me off. Thank you OSS saving me once again.

i have a NEW #62 in your parts diagram and the Correct and updated OEM Clamps too you require

i also have #64 if u happen to need it ? NEW as well too

NO used or pre owned parts on this topic to be clear

PM me please

thanks

kinldy matt