Power steering...did I F it up?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Spook50

Skål
Supporting Vendor
Joined
Feb 16, 2005
Threads
810
Messages
7,674
Location
Spokane, WA
Okay, after changing out the power steering fluid in my truck, it's acting weird. Even after bleeding it out and adjusting the screw on the gearbox. It acts fine when turning to the right, but if I turn to the left, I get an initial shap resistence, and then it turns fine. The resistence is as if I had it against the stop. any ideas what might be causing this? It's driving me nuts!!
 
Adjusting the screw on the box can be dangerous. How much did you tighten it? More than one turn - its probably too tight. Its not meant to be adjusted by feel in the the truck. I'd back the adjuster a bit and put the front axle up on jack stands. You can then turn the steering without any added resistence of the tires scrubbing the ground. If something besides the box is binding, it should be more obvious with the tires up. Its also easier to completely push the air out of the hydraulic system that way.
 
60wag said:
Adjusting the screw on the box can be dangerous. How much did you tighten it? More than one turn - its probably too tight. Its not meant to be adjusted by feel in the the truck. I'd back the adjuster a bit and put the front axle up on jack stands. You can then turn the steering without any added resistence of the tires scrubbing the ground. If something besides the box is binding, it should be more obvious with the tires up. Its also easier to completely push the air out of the hydraulic system that way.

It didn't bind at all while I had it up on jackstands earlier (to bleed the system). I looked underneath the truck and couldn't see anything that could be binding. When it resists, it gives me that slight whine/moan as if it's against the stop. Is that any indication that the steering stabilizer might be getting ready to take a dump?
 
just a dumb question here, but did you use 'power steering fluid', or ATF?
 
beaufort-fj60 said:
i thought moan was from air in the system

Normally it is, but other things can cause it. That's just the first thing I look for, after working on hydraulic problems on our jets. Though this is a different moan than what air in the system usually sounds like in my rig. It just sounds like it's straining like when it's against one of the stops. Though it's getting less and less the more I drive it, so maybe it actually WAS just a pocket of air getting worked out. It's still there at low RPMs, and only if I turn the wheel quickly from being centered. I'm gonna tinker around with it more and see if I can remedy it. Nothing's leaking or wobbling, so fortunately it doesn't look like I'll have to fork out the bucks to rebuild (or replace) the pump or gearbox :eek:

Doc: I used Mobil 1 Dex3 ATF. The fluid I changed out was as black as used engine oil though. I was more than a bit overdue :whoops:
 
Back
Top Bottom