can a performance coil like a mallory or bosch coil be used to replace a stock coil and still keep all the other electrics connected that are attached to the coil?
thanks
jim
thanks
jim
performance coil question
- Thread starter 2badfjs
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Can't help you on your question Jim, but I have a small quesiton of my own for you, what ever happened to your 60 series front bumpers? Didnt see them on your site yet...
PM me if you dont want to crud up this thread.
Hope your question gets answered
-Carl
PM me if you dont want to crud up this thread.
Hope your question gets answered
-Carl
- Thread starter
- #3
Can't help you on your question Jim, but I have a small quesiton of my own for you, what ever happened to your 60 series front bumpers? Didnt see them on your site yet...
PM me if you dont want to crud up this thread.
Hope your question gets answered
-Carl
it got moved here
https://forum.ih8mud.com/merchandise-storefront/268835-coming-soon-thread-near-you.html
yes it can
Mark...
Mark...
Yes, I've been running an accel super stock for over a year now.
sterling
SILVER Star
fliphkd778
did you see any noticable performance improvements?
did you see any noticable performance improvements?
Do not expect to see any difference in your performance from an adtermarket coil installed on an otherwise stock 2F.
Mark...
Mark...
would you still run the stock gap, or wider? any advantage? If not in power - ease of starting?
rob
(PS - SROR bumper will kick A$$!)
rob
(PS - SROR bumper will kick A$$!)
When I suspected my factory coil was going out, I replaced it with an MSD Blaster 2 coil (when they were made in the US; now they're Chinese made) and it felt like a huge improvement. Would've liked to compare it directly to a new stock coil because I think the biggest reason for the performance jump was from mine going out.
I've since switched to a Mallory Promaster that's controlled by a Mallory Hyfire 6AL, which in turn is triggered by my factory igniter (so I could retain use of the factory tach and not risk issues with the ECU). Haven't had a problem at all, though I had to make a bracket to mount the Promaster coil.
I've since switched to a Mallory Promaster that's controlled by a Mallory Hyfire 6AL, which in turn is triggered by my factory igniter (so I could retain use of the factory tach and not risk issues with the ECU). Haven't had a problem at all, though I had to make a bracket to mount the Promaster coil.
- Thread starter
- #10
not looking for performance, i just have new coils laying around and had a idea of replacing my stocker.
thanks all
I used MSD for years
