bluehawk
Appalachia Cruisers
Need at drivers side, outside door handle. If anyone in the Knoxville or surrounding area might have one, please let me know.
Part Needed (1 Viewer)
- Thread starter bluehawk
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
$45 your cost for a new one. Shoot me an email or a message if you want to order one.
did you see that guy in the FS thread parting out a 60 here in Chattanooga?
bluehawk
Appalachia Cruisers
- Thread starter
- #5
nope but I will check it out. Hey Sk8, how hard is it to pull a 2F and rebuild one. Not sure if mine is good right now. Did a compression test on the first three cylinders and #1 was at 25 and #2-3 at 0 psi. Gonna do a leak down test tomorrow and see what the results are.
bluehawk said:
A little harder to pull a motor in a 60 since the tranny comes out too. But it is not hard. Rebuilding an engine is just that. Gotta find a good machine shop and know what you are doing with that.
Sent from my thing with Woody's junk.
