Paragoud Arkansas miscellaneous parts summer knows some are not (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

kiley7483

New project
Joined
Dec 25, 2016
Threads
39
Messages
279
Location
paragould ar
Location
United States
Couple new tail lights from cruiser corp looks like one signal or whatever light for fender some marker light housings distributor says I think 29j00-027-2 definitely factory Lakers either off of 69 or 76 fj40. Also have 2f has been pulled couple years now. 5 of the cylinders have 139 compression one has 136 spun bearings crankshaft. It's complete minus the factory carb which I do have I have three carburetor for it I put hei distributor in it and ran about 3 weeks and spun bearing. Also got two clutch pressure plate went out of 76 one out of the 69 69th little rough 76 model and looks no I'm not going to use them send me a message tomorrow

IMG_20220703_005544891.jpg


IMG_20220703_005601532.jpg


IMG_20220703_005939104.jpg


IMG_20220703_005934715.jpg


IMG_20220703_005716596.jpg
 
Couple new tail lights from cruiser corp looks like one signal or whatever light for fender some marker light housings distributor says I think 29j00-027-2 definitely factory Lakers either off of 69 or 76 fj40. Also have 2f has been pulled couple years now. 5 of the cylinders have 139 compression one has 136 spun bearings crankshaft. It's complete minus the factory carb which I do have I have three carburetor for it I put hei distributor in it and ran about 3 weeks and spun bearing. Also got two clutch pressure plate went out of 76 one out of the 69 69th little rough 76 model and looks no I'm not going to use them send me a message tomorrow

View attachment 3048757

View attachment 3048758

View attachment 3048759

View attachment 3048761

View attachment 3048762



how much is this orange lamp ?



do u have a pair ?

thanks



1656832016492.png
 
I think there is only one but I can look in attic tomorrow I have a box of other stuff I will check and get back to you if so 60 for the pair plus the ride


ok im in

for a pair or single

thanks please PM me and let me know

matt
 
Lots of good parts I bought the truck from the man who bought brand new it didn't run at the time I put a HEI distributor in it and a new carburetor on it drove it 3 weeks and it's spun a bearing but every part the man to take it off of the motor was laying in the back of the truck in the box and it has original carburetor aftermarket carburetor and a brand new caubeter I bought 2 years ago on it the original carburetor was in the back and replaced again last I checked the pressure was 139 on 5 cylinders and 136 also had the clutch pressure plate and throw up bearing all of the brand new considering how old it is inthe perfect bell housing is good like I said I drove for 3 weeks and it's going to bearing then I went through a divorce so now I'm going to be at conversion the wiring harness is here complete wiring harness for it but if you had on but it's got all the knobs the red leaving the red whatever the red red knob is one two three four five six knobs fuse box new regulator there is a guy trying to buy the two with motor now so he's got first dibs on it and also I got to read your plastic fan I think it's 69 or 76 I had two of them also having one f block bear head and a few other parts for it
 
Can you measure the taillights please. Interest in them if they are +/- 3 1/4”
They are 5 in across the part number is 815-50-60130 also on about on the lens it says Toyota fj1 SAE 1968 Japan dot they're brand new for Toyota

IMG_20220704_092655040_HDR.jpg


IMG_20220704_092703882_HDR.jpg
 

Users who are viewing this thread

Back
Top Bottom