on the car brake lathe (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 29, 2019
Threads
18
Messages
169
Location
91107
has anyone used a bosch on the car brake lathe i believe model number ocl 8850? looking to use on a 80-100 series.
 
Last edited:
Looking at the video it looks like it's going to clear the Hub. I'm just concerned how it's going to mount up at the caliper bracket.
 
Supposedly one of those two adapters should fit. I'm buying used I want to make sure it's going to mount properly. When you say knuckle mount adapter are you talking about where the caliper bolts on to the knuckle?
 
Supposedly one of those two adapters should fit. I'm buying used I want to make sure it's going to mount properly. When you say knuckle mount adapter are you talking about where the caliper bolts on to the knuckle?
Ya. Looks like u need the right bracket to bolt in place of the caliper.
 

Users who are viewing this thread

Back
Top Bottom