Installed my OME 2" lift a couple weeks back and now realizing I need a spacer since I binned the spring isolator. Anyone happen to have the spacer dimensions for the medium lift kit? Would like to knock it out this week but the shipping for a glorified washer is ridiculous, can probably make my own if anyone knows the dimensions?
OME rear spacer (1 Viewer)
- Thread starter MJC70
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Rough dimensions from when I did mine (copy and paste):
"The rear spring center pin is only 15mm OD, but the rear axle has a 25mm ID hole in it..."
forum.ih8mud.com
Hope that helps.
- Brian
"The rear spring center pin is only 15mm OD, but the rear axle has a 25mm ID hole in it..."
Builds - V8 (SBC) to V8 (Gen III Vortec) swap in my FJ60...
There is (max/min distance you should follow) if you are planning on keeping it 50 states smog legal... As Elbert stated keeping it as close as possible to stock would be your best bet..... My Cats are about 11" to 13" from EM with pre and post 02 sensors. My $0.02
forum.ih8mud.com
Hope that helps.
- Brian
Last edited:
