Old Man Emu upper shock rubber grommet (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 14, 2009
Threads
6
Messages
25
Location
Arizona
Anyone know where to get one? It is gonzo... been missing for about 6 months. Glad I was doing a PS swap because I couldn't figure out where the rattling was coming from every time I went over a bump!
20220102_163132.jpg
 
These are the ones I have. When the OME shocks ship as a set, one end needed to get the bushings swapped to fit the studs -- I can't recall which, though. These are 18mm ID, looks like the replacements had smaller ID, possibly for the rears. (Those are the bagged ones)

If that's the size you need, happy to toss one in an envelope and I'll toss the other in my glovebox.

PXL_20220103_020523032.MP.jpg


Screen Shot 2022-01-02 at 8.09.03 PM.png
 
No worries. The washer covers up the p/n on the ones on the rig here too.

I'm fairly certain they're the right ones...I want to say the rears have smaller studs than the front, but it's been almost a year since I did the work.

Report back, then I'll know what I have too. 🤣
 
No worries. The washer covers up the p/n on the ones on the rig here too.

I'm fairly certain they're the right ones...I want to say the rears have smaller studs than the front, but it's been almost a year since I did the work.

Report back, then I'll know what I have too. 🤣
So they came in. The number on the rubber is 1178/6. Here is a photo. Probably the same thing.

20220106_113133.jpg
 

Users who are viewing this thread

Back
Top Bottom