Old Man Emu upper shock rubber grommet

[Stoney]

Anyone know where to get one? It is gonzo... been missing for about 6 months. Glad I was doing a PS swap because I couldn't figure out where the rattling was coming from every time I went over a bump!

 

[DSRTRDR]

call Kurt @cruiseroutfit

 

[Stoney]

Copy. Thanks.

 

[zerotreedelta]

I might have one on the shelf...but I don't recall which eyelets are which size, will have to measure. I'll try to check later or tomorrow...

 

[zerotreedelta]

These are the ones I have. When the OME shocks ship as a set, one end needed to get the bushings swapped to fit the studs -- I can't recall which, though. These are 18mm ID, looks like the replacements had smaller ID, possibly for the rears. (Those are the bagged ones)

If that's the size you need, happy to toss one in an envelope and I'll toss the other in my glovebox.

 

[Stoney]

Thank you @zerotreedelta. Will do my research and let you know. Thank you for the response!

 

[Stoney]

Thank you @zerotreedelta. Will do my research and let you know. Thank you

Couldn't verify that part number on the bushings. Ordered from cruiser outfitters who had some in stock. Probably the same damn ones but didn't want you to have to go though the trouble without knowing for sure.

 

[zerotreedelta]

No worries. The washer covers up the p/n on the ones on the rig here too.

I'm fairly certain they're the right ones...I want to say the rears have smaller studs than the front, but it's been almost a year since I did the work.

Report back, then I'll know what I have too.

 

[Stoney]

No worries. The washer covers up the p/n on the ones on the rig here too.

I'm fairly certain they're the right ones...I want to say the rears have smaller studs than the front, but it's been almost a year since I did the work.

Report back, then I'll know what I have too.

So they came in. The number on the rubber is 1178/6. Here is a photo. Probably the same thing.

 

[zerotreedelta]

Now we both have spares!