OEM Locker Dial Dimensions (1 Viewer)

[Will Van]

Does anyone know the dimensions of the OEM locker dial? Dimensions in mm preferred.

It appears to be square (same length x width).

 

[flintknapper]

Outside to Outside as you have depicted....mine measures about 44mm each direction. But its difficult to get an exact measurement as the switch is recessed a bit. Of course that doesn't represent the 'opening' in the dash....just the outer dimensions.

 

[Will Van]

Outside to Outside as you have depicted....mine measures about 1"-3/8 or tad under 35mm each direction. But its difficult to get an exact measurement as the switch is recessed a bit. Of course that doesn't represent the 'opening' in the dash....just the outer dimensions.

Thank you!

 

[Will Van]

Can anyone double-check these measurements for me? 35mm x 35mm seems small for the dimension .

 

[flintknapper]

Thank you!

Edited to revise: Actual measurement (on my 97) is 44mm (square).

Can anyone double-check these measurements for me? 35mm x 35mm seems small for the dimension .

Edited previous post, actual measurement is 44mm.

 

[Will Van]

Edited to revise: Actual measurement (on my 97) is 44mm (square).



Edited previous post, actual measurement is 44mm.

View attachment 2900947

Thank you!

 

[Delta VS]

 

[Will Van]

View attachment 2901045View attachment 2901046View attachment 2901047View attachment 2901048View attachment 2901049

Thank you! That is (precisely) what I needed.

It looks like it's approximately 44mm tall x 44mm wide.

 

[Delta VS]

Thank you! That is (precisely) what I needed.

if you want any other dimensions, just let me know