O2 Sensor studs? (1 Viewer)

[98 SNAKE EATER]

Anyone know the thread size of the Oxygen Sensor studs and where I can get them?

I have an O2 sensor I need install, but I wanna have a pair on hand just in case cause everything looks pretty rusty

 

[ERG80]

O2 sensor studs available/Part number?

So in replacing my exhaust, the cat-back borla system comes with o2 sensor studs, but they are too short to use the OEM locknuts. I looked on Toydiy and did some searching here but can't find a definitive part number for the sensor stud? Anyone know if these are available? Maybe another model...

forum.ih8mud.com

There may be a possible Toyota part number in this thread and an alternative from McMaster in the last post.

McMaster-Carr

McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.

www.mcmaster.com

 

[Kernal]

Very old thread, no idea of Slee still sells this, but other web sites sell
replacement Toyota O2 sensor bungs and studs (maybe a standard size for most models??)

O2 Sensor Bungs for Toyota Studs Style O2 sensors

How many hours have your spent cutting O2 sensor bungs from old exhaust to re-use them? Well, now you can just buy them. Or have you tried to remove a rusted O2 sensor only to mess up the mount? We now offer new machined O2 sensor bungs supplied with new Toyota studs and nuts. They are...

forum.ih8mud.com

 

[98 SNAKE EATER]

Thanks for the info

Placed an order with McMaster and of course shipping was 3 times the cost of the part, but still worth it just to have it on hand

 

[NKP Garage]

They're just 8x1.25 studs. Cheap to get them in stainless on amazon: uxcell a16071500ux0189 M8 x 50 mm 1.25 mm Pitch 304 Stainless Steel Fully Threaded Rods Fasteners 20 Pcs Pack of 20: Amazon.com: Industrial & Scientific - https://amzn.to/399LgMs