November meet up
- Thread starter JackZilla
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #62
No. Cut the ball end off and attempted to drill it out. Metal is just too hard. I think he is going to get the right tools and give it a shot tomorrow.
I'm going to bring a oxygen acetylene torch, if that doesn't work we will be forced to drill it out but I nay have to buy a specail drill bit I dono.
Kyles truck is back from the dead. He used the acetylene, not even 5 minutes it was done.
On another note I just finish my Charlie Brown Christmas tree.
My wife and I also made some Volcom Stone ornaments and the stocking we had from last year when we bought merchandise from the outlet.
Sent from my hawn finga using IH8MUD
On another note I just finish my Charlie Brown Christmas tree.
My wife and I also made some Volcom Stone ornaments and the stocking we had from last year when we bought merchandise from the outlet.
Sent from my hawn finga using IH8MUD
That's rad, I love Volcome!
Thanks for all the help guys, like Dain said it popped right out with the proper amount of heat and I am back on the road. Not I have to do the tie rod ends I hope they will be much easier.
Thanks for all the help guys, like Dain said it popped right out with the proper amount of heat and I am back on the road. Not I have to do the tie rod ends I hope they will be much easier.