I won't be needing this anymore. I have a late model crossmemeber (late four-speed or 5-speed with 3F bell housing) from which I removed about an eight-inch section and welded in a couple pieces of angle iron with a high degree of tilt to accomodate my CV equipped front driveline and SOA conversion with an H55F. It has a few years of "testing" on it to prove whether or not I know how to weld (Don't worry, I'm good at it!) and has proven to be tough enough for airing out your Cruiser and with a deep enough relief to clear any imagineable driveline angle. It's in Salt Lake City, I'll take $50 for it and you won't have to stay up all night and fab you own. I do not have the tranny mount as mine was disintegrating badly. PM me your email and I'll send pics. You may call me too, (801) 471-8315, Mike.