Y'all,
After a bit of trail riding, I opened my tailgate and my '4WD' badge fell off right onto my bumper
I noticed that the PO but on pipe tape over the rubber wedges that sit on the plastic pin and stuck it in the pre-drilled holes. I have a feeling it was done differently at the factory.
How do I do this properly?
THANKS! (I'll post pics of trailer riding and of it cleaned up later tonight)
After a bit of trail riding, I opened my tailgate and my '4WD' badge fell off right onto my bumper
I noticed that the PO but on pipe tape over the rubber wedges that sit on the plastic pin and stuck it in the pre-drilled holes. I have a feeling it was done differently at the factory.
How do I do this properly?
THANKS! (I'll post pics of trailer riding and of it cleaned up later tonight)
Last edited: