Greetings:
Looking for some guidance. When I activate the high beams either by pushing the stalk or pulling the stalk, I will get the dash light indicating that the high beams are on. However, they are not on and I am not getting voltage at the bulb socket. Since the dash light comes on, can I rule out the push/pull switch? If so, any suggestions of where to start looking?
Thanks,
Steve
94' 360,000 miles
Looking for some guidance. When I activate the high beams either by pushing the stalk or pulling the stalk, I will get the dash light indicating that the high beams are on. However, they are not on and I am not getting voltage at the bulb socket. Since the dash light comes on, can I rule out the push/pull switch? If so, any suggestions of where to start looking?
Thanks,
Steve
94' 360,000 miles