New Flame Thrower - WTF???! (1 Viewer)

[a77fj40]

Ok so i just got my pertronix ignition in and i went to put the Flame Thrower in and it's like 1/2 an inch smaller in diameter than my stock coil and the bracket won't tighten down around it.

Has anyone else had this problem and what did you use to fix it? i thought about some rubber spacers or just shoving some cardboard in there or something but i thought i'd get some feedback.

So what do you think?


db

 

[dgangle]

cardboard? you are kidding, right?

I suggest modify or make a new bracket.

 

[Pighead]

I used a piece of closed cell foam for a spacer...

 

[stamp]

Cut a couple strips of rubber from a inner tube the width of the bracket> wrap the coil tighten clamp

 

[1975FJ40]

I used a piece of rubber. The inner tube idea sounds good.