NEw bumper for the 60 (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

NCFJ

Supporting Vendor
Joined
Jan 22, 2007
Threads
215
Messages
10,301
Location
Chesnee, SC
I was able to finish up all but the fuel can rack and the latch cam on the new tube bumper for the 60 series yesterday and got it installed this morning. The bumper can be built with or without a swing out. This swing out will have a removable 2 can rack and provisions for mounting a Hi-Lift jack as well.

The OEM rear cross member must be removed and is replaced with a 1.5” X 2.5” .188” wall rectangular tube in it’s place as part of the bumper. The bumper itself is far stronger than the OEM cross member but the rectangular tube also acts as the rear mounting point for the 2” receiver. There are also provisions for mounting recovery shackles that are .75” thick and mounted directly to the frame ends. The bumper mounts with 8- 1/2 ” grade 8 bolts and 12- grade 8 3/8” bolts. 8 of the 3/8” bolts replace the rivets that are drilled out of the rear most body mounts.

5765484720_7cb09bf1f9_b.jpg

5765485182_f62fea10f5_b.jpg

5764939005_d442e7408d_b.jpg
 
More pics


5765486246_612760f21c_z.jpg

5764938037_bac28a8a02_z.jpg
 
I like!!
 

Users who are viewing this thread

Back
Top Bottom