Wanted NEED rear door latch/lever for 1968 FJ40

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Status
Not open for further replies.
Joined
Jun 18, 2008
Threads
111
Messages
760
Location
Sonoma, CA.
Location
United States
one of the arms to the lever on mine is broken and needs replacement. I have to open from the inside until this is fixed.

anyone know where i should look???

ready to buy ASAP!!!

thanks

i know its a terrible pic, but this is what i need..
Latch pic.webp
 
i am still in need of this part...any ideas on where if nobody has one they want to sell??
 
reasonable my ass! in all honesty, a new handle isnt worth more than $20. Thats why im lookin for used, rusted ones.
 
forget the ccot piece of junk.


buya new one from the dealer. they're not cheap but they work.


here's how to make them last:

when you get ready to open the lift gate, take your left hand and puch against the bottom of the gate. that takes the load off the hook on the inside of the handle. while applying pressure with your left hand, use your right hand to pull on the hanlde to release the hook. it will open well every time and won't break off.

the handle breaking is due to a slight design flaw that puts all the load on the hook portion of the handle. take the pressure away and it won't break.


hth

georg @ valley hybrids
 
X2 on what goerg said.

THe two striker on both sides has to be pulled in to release the hatch. Too keep the rattling down on the hatch I keep the latch adjusted tight. SO by pushing in on the hatch is help release that pressure so your only having to overcome the spring pressure of the strikers. The handle always breaks or aleast for me is where the notch is in the handle for the lock. This is the thinnest spot.

The last time one broke for me I just replaced with new from Toyota even though I had a used one laying around at the time. Certain things I replace with new even I could find it used this is one of them, most used ones are probably on a short life from previous use. If you couldn't get them new then that would be a different story.
 
too bad the ccot handle is poop... I've already replaced a rear handle on the pig a few years ago so I know handles are overpriced. i've never seen a 40 series hatch handle for sale. what would it take to fab one up? my bad on the link, ty
 
you are AWESOME!!! thanks..Findlay Toyota in LV quoted me the above statement
 
Next time you go to a dealer say it's for a 4/69 FJ40. Dealers sometimes seems to be lazy when it comes to these old cruiser. Parts books don't go past 3/69 so they have no listing for earlier than that date.
 
Status
Not open for further replies.
Back
Top Bottom