So, did a tune up in the 96 LC, new plugs, wires, dizzy cap n rotor, found a ground in the wrong place, I’ll post photos, and videoI was getting code P0330 before, so I cleared the codes, truck seemed to run fine for about 30 mins now I’m getting these 3 codes. Truck seems to be running ok, seems hesitant at first but then smooths out after 1st gear, took it off road seemed like it was gonna stall on some hills. Good thing it’s running and driving now, will fire up every time, idk if this is normal but sometimes I got to start it and get nothing (no crank) after a few second delay or turning it to off and back on it will fire right up. I’ll post photos n have a video of it running. Tomorrow I’m gonna try n clean the MAF, the 0330 is a knock sensor and an o2 sensor, I ordered the knock and o2 sensor, should be here in about a week, anything I should check in the meantime or rule out? TIA for the help, this forum has been tons of help! The ground I moved to the side of the intake, that’s where it looked like it went, if not lmk.