Planning to replace these and the bushings at the axle end. The nut came loose easy enough, but beyond that these things are locked in - cannot budge either one.
Any tricks I can use that won't destroy the finish on the tubes? I have a heat gun - not sure that will get hot enough. I soaked them overnight with mass quantities of PB and tried to loosen while still attached to the axle housing. Much more force and I'm afraid of bending the mounting tabs.
I ordered new, complete joints figuring this end might get destoyed...
Any tricks I can use that won't destroy the finish on the tubes? I have a heat gun - not sure that will get hot enough. I soaked them overnight with mass quantities of PB and tried to loosen while still attached to the axle housing. Much more force and I'm afraid of bending the mounting tabs.
I ordered new, complete joints figuring this end might get destoyed...