If anyone has a few hours to spare in the evenings this week, I have my 60 series axle rebuilt and need to figure out how much I need to move my front spring hangers out to mount the wider axle. I'll have to measure and move around an axle alot and it is too much for me to do alone.
If anyone wants to hang out for a few hours in the evenings this week, I would supply the beer or soda. I have a plasma cutter to move the process along.
Once I get the hangers tacked in place, I can do the rest on my own. The only pain is putting the new axle on the springs, measuring how much I need to move them out based on the axle perches, and burn the old hanges out and make some gussets.
Dan
If anyone wants to hang out for a few hours in the evenings this week, I would supply the beer or soda. I have a plasma cutter to move the process along.
Once I get the hangers tacked in place, I can do the rest on my own. The only pain is putting the new axle on the springs, measuring how much I need to move them out based on the axle perches, and burn the old hanges out and make some gussets.
Dan