smokeater
SILVER Star
So I pulled my front and rear driveshafts in order to replace u-joints. I’m restoring ancillary driveline parts while I’ve got the 40 in the air. I noticed one of my yoke’s is an 8mm flange pattern while all others are the post ‘74 10mm.
My question is, is there any reason I can’t drill out the oddball flange to 10mm? Both diffs are 10mm flanges along with Trans and Drum E-Brake posts?
Looks like the ears will accommodate the width but the footprint of the flange is slightly smaller than the other three.
Thanks in advance for your time!
~smokeater
My question is, is there any reason I can’t drill out the oddball flange to 10mm? Both diffs are 10mm flanges along with Trans and Drum E-Brake posts?
Looks like the ears will accommodate the width but the footprint of the flange is slightly smaller than the other three.
Thanks in advance for your time!
~smokeater