Need a measurement if possible 2uz crank pulley (1 Viewer)

[Wadepat2]

Trying to finish up supercharger install and only seeing 4psi boost at sea level. I have GCC spec so trying to confirm crank pulley diameter OD for belt. Outer Edge to outer edge.

Anyone have one sitting around they could measure for me. My belt went on super easy and everyone else with SC says it should be near impossible.

 

[neoworm]

Ive got one sitting on my bench from a 2005 2uzfe. That what you are looking for? You didnt say what emgine.

 

[Wadepat2]

Ive got one sitting on my bench from a 2005 2uzfe. That what you are looking for? You didnt say what emgine.

Yep that would be great

 

[neoworm]

Outside dia. of the front face is 146mm. Roughly 141mm dia. If I measure the tops of the pulley ribs.

 

[Wadepat2]

Outside dia. of the front face is 146mm. Roughly 141mm dia. If I measure the tops of the pulley ribs.

Great thanks

 

[neoworm]

No problem