I am in early stages of laying out a scratch build trailer that will incorporate either the AT or locknroll. While I am planning on making the tongue able to extend, I would really like to get the most out of the extension by incorporating the length of the coupler in my design from the beginning.
Having said all that what I would like to know is ...
1. the distance from center of the pin (the tongue will be receiver tube) on the trailer side and the center of where it mounts on the tow vehicle's drawbar.
2. The distance between the center of trailer side pin to the first obstruction that will keep it from sliding any further into the tongue.
Thanks in advance,
Having said all that what I would like to know is ...
1. the distance from center of the pin (the tongue will be receiver tube) on the trailer side and the center of where it mounts on the tow vehicle's drawbar.
2. The distance between the center of trailer side pin to the first obstruction that will keep it from sliding any further into the tongue.
Thanks in advance,