Mounting reservoir/filter for Full Hydro (1 Viewer)

[brokenparts]

I'm a little cramped for room to mount my reservoir for my psc pump. I wondering there is a general rule on how you need to mount it above the pump. In this location it has about a 6-7 inch drop and about 6 inches from the pump laterally to the rezzy. Good? Bad? Ok?

sorry for the terrible pic:

 

[mookie]

i think as long as you can get it above the pump your golden

 

[Tapage]

i think as long as you can get it above the pump your golden

X2 .. allow a cuple of inches over the pump .. it's most gravity that make the fluid intothe pump ..

My factory PS reservoir on Tencha was at least 2' ( feets ) away of the PS pump .. ( factory setup ) and around 8 inches over the PS pump .. ( just for reference )

 

[Sputnik40]

Looks good - should be fine for prolonged ascents. Where is the cooler - if you have one, it has limitations on where it can go as well...

 

[brokenparts]

I'm running this cooler:

(DER-13253) Derale 12 Heat Sink Cooler Kit [DER-13253] - $75.00 : PSC Motorsports, Off-Road Steering Experts

Plumbing is going to get somewhat complicated because I'm also running hydroboost brakes (hi-flowed from Vanco). I plan on running the cooler near the bottom of the grill near the radiator. I'm open to other ideas if the cooler should go somewhere else.

 

[Tapage]

should be enough .. ?

what I'm using ( and still thinking in a bigger one )