Motorcraft Carb Pics? (1 Viewer)

[TJDIV]

To perhaps "assist" in me in installing this Motorcraft carb, can anyone with one of these already on please take a few pics for me?

If ya don't wanna go through resizing them to post them, etc, an email to:

FJ45LV@Cox.net is fine.

Thanks in advance. TomIV

 

[JasonH]

Whaddya want to see? I can go out and snap a couple if you still need 'em. You mean on a 2F right?

 

[Texican]

https://forum.ih8mud.com/showthread.php?t=41340

Pix in this thread. page 5 if ya' don't want to hunt

 

[red dirt squirt]

unfortunately i do not have any pics but, i just went through this ordeal. i had a motorcraft rebuilt and when i put it on everything ran perfectly with only a slight bit of carb tuning. what i am thinking you might have problems with is the accelerator linkage. i had a hell of a time with mine clearing the master cylinder. all and all the best advice i can give you is to bolt it on and see what type of room you have and then maybe hit up napa or oriely's for the necessary linkage after you see what kind of room you have. good luck.

 

[TJDIV]

fudged with it a little last night........it's going to be a piece of cake I think. All the linkage and s*** was included by the seller from Ebay.

Should be a good upgrade over a Holley, no?