Guys. I am replacing my front rotors. I removed the cover and found this on both sides. Am I missing a bolt and washer. The manual shows one. How important is it? Anyone have one in Pasadena ca?
Missing bolt! Anybody have two?! (1 Viewer)
- Thread starter alvin9
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
brian
SILVER Star
on the axle?
you're fine.
you're fine.
This hole ?
Only put a bolt/washer in there when you need to pull the axle out (only will move 'bout 1/2") to get to the notch for the c-clip. It's just a M8 x 1.25 bolt. You've got about 500 of 'em on your truck...
Only put a bolt/washer in there when you need to pull the axle out (only will move 'bout 1/2") to get to the notch for the c-clip. It's just a M8 x 1.25 bolt. You've got about 500 of 'em on your truck...
- Thread starter
- #5
Thanks guys! Got nervous there for a second
inkpot
SILVER Star
Howdy! You should have a snap ring just inboard from that, about 1/4" down the splines. It captures the inner section of the hub to the outer end of the birf stub. Looks good to me as is. I'm pretty sure I can see the snap ring hiding in the grease. John
