Master Cylinder Adjusting Tool (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 5, 2020
Threads
8
Messages
39
Location
California
I needed the tool to adjust the clearance on my master cylinder pin, but the soonest I could get one was a week out. So, having a 3D printer, I chose to make my own. The pin is just a 4" length of 1/4 rod I had laying around. I ground one end into a dome shape. I also happened to have an 8-32 thumb screw in my junk drawer, it's only installed in the last picture. STL file attached, in case you happen to have your own printer.

IMG_0810.JPG
IMG_0812.JPG
IMG_0813.JPG
 

Attachments

  • Gauge 2021-03-26 02.stl
    84.6 KB · Views: 29

Users who are viewing this thread

Back
Top Bottom