So I bought these spacers
http:///www.man-a-fre.com/pa/80seriescoilspringspacers.htm
and when trying to put them on, the inside diameter is too small, they do not go on the cones all the way up, and also the spirngs do not go ovet the lip either, the diameter of the lip is too large .
I trimmed around the lip, so the springs slide onto it, but the inside diameter seem hard to get to-to trim. Have you guys had this problem. Seems like a pain in the ass, surprised they could not get the diameters right. I have installed them, and they are about 0.5" away from being snug all the way to the top. Drove a couple of days, put grease, nothing, will not move.
Should they slide easily onto the cone? or should they be pressed in with some force?
Thanks in advance
Vadim
http:///www.man-a-fre.com/pa/80seriescoilspringspacers.htm
and when trying to put them on, the inside diameter is too small, they do not go on the cones all the way up, and also the spirngs do not go ovet the lip either, the diameter of the lip is too large .
I trimmed around the lip, so the springs slide onto it, but the inside diameter seem hard to get to-to trim. Have you guys had this problem. Seems like a pain in the ass, surprised they could not get the diameters right. I have installed them, and they are about 0.5" away from being snug all the way to the top. Drove a couple of days, put grease, nothing, will not move.
Should they slide easily onto the cone? or should they be pressed in with some force?
Thanks in advance
Vadim
Last edited: