Hi all,
I know there are multiple topics of using the Height offset utility in techstream, from everything I read all the instructions seem to be for trucks that have never had the height sensors adjusted or moved.
So my question is how do I reset or correct height after I physically adjusted the sensors? I maxed out the sensors heights physically and then went back to readjust and try to go back or close to stock height 6 months ago. Truck has been driving fine but I would like to fine tune it in Techstream.
Below are 2 photos. Both are on level ground and tire pressures are set the same all the way around
First one is from a stock (except for tires) of a 2010 LX570
2nd is my LX570 Flat ground in N
Any help is appreciated!
I know there are multiple topics of using the Height offset utility in techstream, from everything I read all the instructions seem to be for trucks that have never had the height sensors adjusted or moved.
So my question is how do I reset or correct height after I physically adjusted the sensors? I maxed out the sensors heights physically and then went back to readjust and try to go back or close to stock height 6 months ago. Truck has been driving fine but I would like to fine tune it in Techstream.
Below are 2 photos. Both are on level ground and tire pressures are set the same all the way around
First one is from a stock (except for tires) of a 2010 LX570
2nd is my LX570 Flat ground in N
Any help is appreciated!