Lumbar adjustment

Discussion in '80-Series Tech' started by bkgiii, Mar 18, 2004.

  1. bkgiii

    bkgiii SILVER Star

    Messages:
    479
    Likes Received:
    0
    Joined:
    Mar 28, 2003
    Location:
    Gulf Coast
    Quick / easy question. How would I remove the lumbar adjustment wheel from the DS front seat, right side seat? Also, anything I need to be careful with when removing front seats?

    On a related note....I aquired new leather seats (without the frames), and am replacing mine. ANyone needed some slightly worn seats (tan) , lemme' know....
     
  2. CDN_Cruiser

    CDN_Cruiser

    Messages:
    1,048
    Likes Received:
    2
    Joined:
    Mar 27, 2003
    I would think that it is probably just on a spline and would pop off - but the spline may still protrude. Isn't that wheel to adjust the 'width' of the seat (ie the 2 wings)? If your truck is the same as mine, lumbar is an air bladder with a switch near the seat controls.

    Did you get OEM leather of after market?

    Cheers, Hugh
     
  3. bkgiii

    bkgiii SILVER Star

    Messages:
    479
    Likes Received:
    0
    Joined:
    Mar 28, 2003
    Location:
    Gulf Coast
    Right , Hugh....that's what I meant...the wings. Thanks...worst that can happen is I break it and Cdan bails me out (again)
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.