Outsane
Supporting Vendor
In case it helps some one else.
This took me half a day in my tilted driveway, spare was already removed.
I mostly followed the instructions, these are just some things I did that are 80 specific.
Included parts supplied with the tank, front tank mount is attached to the tank with a throw away nut. Use the nylocks for installation
Wiring
I 3dprinted a switch insert available from solvefunction.com
Ran the wires down the left side to a perfectly placed grommet in the rear passenger footwell.
Now to chop!
As the instructions said to cut fuel fill and vent on the inside of the frame rail.
I used a reciprocating saw (sawzall), but did not need to remove or unclamp anything. Deburr please.
This took me half a day in my tilted driveway, spare was already removed.
I mostly followed the instructions, these are just some things I did that are 80 specific.
Included parts supplied with the tank, front tank mount is attached to the tank with a throw away nut. Use the nylocks for installation
Wiring
I 3dprinted a switch insert available from solvefunction.com
Ran the wires down the left side to a perfectly placed grommet in the rear passenger footwell.
Now to chop!
As the instructions said to cut fuel fill and vent on the inside of the frame rail.
I used a reciprocating saw (sawzall), but did not need to remove or unclamp anything. Deburr please.
Last edited: