Line Lock Parking Brake

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 2, 2004
Threads
178
Messages
1,417
Location
Athol, MA
Does anyone know if Line Lock parking brakes are street legal as the only source for a parking brake? ie when the stock mechanical parking brake is eliminated in an axle swap? My state (MA) Inspection reads as follows:

The parking brake on all vehicles will be tested by accelerating the motor to approximately 1,200 to 1,300 RPM's with the vehicle in the lowest forward gear against the brake in the applied position. The vehicle will be rejected if the parking brake will not hold.

Makes no mention of the parking brake being mechanical or a hydraulic (line lock). I will be converting to Volvo portals and the stock drum brakes on the portals have no method of attaching a mechanical parking brake to them. The disc conversions I am told have no provisions for a parking brake either.

Also considered a mechanical disc off the transfer output shaft but, clearance looks to be an issue off the rear...
 
MSGGrunt said:
Also considered a mechanical disc off the transfer output shaft but, clearance looks to be an issue off the rear...


Do it. You could get a drum assembly off of a discovery or rr for pennies on the dollar. It should bolt right to the output flange, and needs no secondary mount. both vehicles are very similar in weight, and the driveline brake does wonders when crawling.

pinion brakes are where it's at. you will be able to crawl down ledges that you would otherwise need 175/200:1 crawl to feel safe on.

The drum is about 13" diameter if I recall.
 
Last edited:
I'm thinking that the Line Lock is the only viable parking brake. One off a discovery would be nice but, the outputs on the tranfercase just don't have enough room around them for this type of install. I'll have to ask a local inspection station if I will have a problem with the Line Lock being legal for a street registered and inspected vehicle.
 
I'm not sure of the compatability, but rear driveshaft parking brake conversion kits are available for Toyota pickups and 4Runners. The bugger would be the transfer case bolt pattern, as the mounting bracket for the assembly mounts to the actual t-case itself. Plus, '79-'95 pickups and '84-'89 4Runners have a horribly designed rear axle parking brake system in which a couple of lever arms hanging on the sides of the drum backing plates seize up and make the parking brakes useless. And on top of that, then the rear shoes won't adjust because the parking brake is what adjusts the shoes.

I must say, the driveshaft parking brake on my '99 Discovery II is very strong. If I forget to release the brake and try to drive away, there's no missing it!
 
I don't know if "line locks" are legal in every state. They are in Texas, and I have a "Jamar" on an Early Bronco I converted to 4 wheel disc. You depress the brake pedal while at the same time pressing the line lock to engage it. It is very positive provided you have no leaks in the system. To disengage simply tap the brake pedal again.

I don't use mine as an emergency brake really, but it satisfies the requirement to have an emergency brake in place. You can run your "rear" brake lines through it and place the unit where ever its convenient to reach the button, I have mine mounted in the floorboard.

The first one lasted 18 yrs., I'm on the second one now. Make dead certain your system doesn't leak though. You can get them from J.C. Whitney for under $30.00
 
Back
Top Bottom