JohnnyC
Long ago TLCA# 2231
I have a lincoln weld pak 100 ....had it for over 10 years....
its just not penetrating the steel as well as it used to...not really thick stuff either 1/16" and 1/8" stuff....just balling up on top and not penetrating
if i put the speed way down to practly nothing and have the arc volts on "D" it will weld 1/16"
where do i check 1st...transformer correct?
how many volts need to come out?
please excuse my bad welding grammer...i'm not the best at it by any means
its just not penetrating the steel as well as it used to...not really thick stuff either 1/16" and 1/8" stuff....just balling up on top and not penetrating
if i put the speed way down to practly nothing and have the arc volts on "D" it will weld 1/16"
where do i check 1st...transformer correct?
how many volts need to come out?
please excuse my bad welding grammer...i'm not the best at it by any means