Ironman lift seems way too high! (1 Viewer)

[ZRTactical]

Just had an ironman 2" nitro lift installed on a 2002 truck. With 33x12.5s on it. There is a huge fender gap. This is even with front and rear bumpers. I selected the 0-440lb springs. Am I missing something? How do I get this thing lower? It's not like any of the pictures I saw on here.

 

[vipergrhd]

Any before and after measurements? It looks level to me, it will take sometime to settle.

 

[ZRTactical]

Level is ok just didn't expect so much gap. I didn't take a before measurement

 

[Manhattan]

My '06, on 33s, looked like that - maybe not quite as high... maybe.
Initially, the truck was level (and rode like crap). I dialed the front down a bit. The ride improved and it just looked better.

This is a few months later...

Specs:

• IronMan torsion bars
• IronMan coil springs; 13B “Performance”; 0-440 lbs. 0-200kg
• IronMan Foam Cell FE (now Pro Foams)
• Rear sway bar ends lengthened 2”
• SPC upper control arms
• 275/70/18 BFG KO2s

Center of hub to edge of fender:

• Rear: 23.25”
• Front: 22”

 

[LandyOverLand]

Sounds like you need some 35s to take care of that gap

 

[ZRTactical]

Thanks! Is that measurement after it settled?

 

[Biga27110]

Looks good just get bigger tires.

 

[jLB]

To me, that looks about normal for a 2-2.5” lift with ~33” tires.

 

[Patassa]

Looks like the front needs to come down, embrace the rake. Otherwise, looks like mine after 2-2.5" lift with 33's.