Hysteer Arms and Tie Rods

[bull]

Location

United States

SOLD: Hysteer Arms and Tie Rods

4x4 Labs complete 4x4 labs setup with FJ80 Tie Rods. Was going onto my 1979 FJ40, but decided against it.


$500 shipped

 

[ginericLC]

Bull, were 79s the large knuckle pattern?

 

[65swb45]

Bull, were 79s the large knuckle pattern?

I am not Bull, but I happily drink his alcohol, and I am here to tell you that YES Eric, the 79 sports the larger knuckle pattern.

 

[CruisinFJ60]

so these will fit a 60?...

 

[zuluzeugma]

so these will fit a 60?...

Yes, but the Ackerman will no longer exist as Ackerman steering is based upon wheel base... Saying that, who really cares when you're going 2 MPH. Its not a rally car.

Doesn't this setup cost $500 new though??? confused...

Oh, and tie rod and drag link will be too short as 60/62 series axles are 3 inches wider than 40/45/55 axles...

 

[bull]

Doesn't this setup cost $500 new though??? confused...

They sell new $550 + shipping.

-| 4X4 LABS |-


Oh yeah these are brand new. They have never been installed..

 

[zuluzeugma]

True story... They must have gone up since the last time I looked... I hate this saving for a ring crap or I'd be all over it...

 

[CruisinFJ60]

Yes, but the Ackerman will no longer exist as Ackerman steering is based upon wheel base... Saying that, who really cares when you're going 2 MPH. Its not a rally car.

Doesn't this setup cost $500 new though??? confused...

Oh, and tie rod and drag link will be too short as 60/62 series axles are 3 inches wider than 40/45/55 axles...

thats what i thought. thanks man.

 

[hellbent40]

This set up for a SOA or just sua

thanks adam

 

[bull]

This is the steering set up you want for SOA

 

[bull]

$475 shipped.

Final offer

 

[CruisinMT]

wi9ll these fit the early 40's? and where in washington are you?

 

[Stumpalama]

Doood! I just ordered mine from Luke last week!
Oh well.

Bump for ya.

 

[bull]

wi9ll these fit the early 40's? and where in washington are you?

Technically yes, but you would have to swap out your knuckle for the larger bolt pattern. You could also talk to luke porter, he may swap the larger for the smaller pattern.

Sammamish Washington (20 miles east of Seattle)

-bull

 

[schlaker]

Are all the ends 80 series ends - how about the end on the tie rod that goes to the box. Will I need to ream out the saginaw pitman arm to accept it?

 

[bull]

Yes that end will need to be reamed to accept the bigger 80 series tie rod end. It can be done easily

 

[lagwagon]

We have the reamer in Davis if it helps.

 

[bull]

One more time with feeling..

 

[bull]

I can deliver to Cruise Moab

 

[hicruise55]

I need to chat with a friend but I am sure he will be all over it... plus I would like to meet ya! I'll get ahold of him tommorrow, glad I got on tonight, its been a while