I bought a used timing plate cover from SOR. It's in ok shape but still has the old gasket on it. The gasket however is rock hard and seems permanently bonded to the timing cover. I could barely chip any of the material off with a pick or pliers. Then I soaked it in a bucket of water with a cup of laundry detergent for two days. This has made only a modest difference, softening the edges a bit.
I have tried using some gasket remover spray from Autozone on other projects and I wasn't impressed.
Next, I may get after it with a dremel and a sanding bit, but I'm a little worried about damaging the metal and screwing up the mating surface.
Another idea I had was to use an enzyme called cellulase to digest away the cork but I'm not sure I can pick this up anywhere and anyway it seems like quite a hassle.
So, does anyone have any clever tips on removing old hardened gasket material from automotive parts.
Matt
I have tried using some gasket remover spray from Autozone on other projects and I wasn't impressed.
Next, I may get after it with a dremel and a sanding bit, but I'm a little worried about damaging the metal and screwing up the mating surface.
Another idea I had was to use an enzyme called cellulase to digest away the cork but I'm not sure I can pick this up anywhere and anyway it seems like quite a hassle.
So, does anyone have any clever tips on removing old hardened gasket material from automotive parts.
Matt