I'm Knee deep into my birfield job and I'm still not sure how much grease to put into the birfields and knuckles.
I looked through several links and I just want to make sure I'm in the ballpark.
I packed the birfield as full as i could and put most of the rest of the 1lb. tub into the crevas between the knuckle and the axle tube. I tried to get it in there especially on the top and the bottom where the knuckle bearings are.
Does that sound about right, or am I under or over adding grease?
If I were to guesstimate I would say I used the better part of the tub.
Bryan
I looked through several links and I just want to make sure I'm in the ballpark.
I packed the birfield as full as i could and put most of the rest of the 1lb. tub into the crevas between the knuckle and the axle tube. I tried to get it in there especially on the top and the bottom where the knuckle bearings are.
Does that sound about right, or am I under or over adding grease?
If I were to guesstimate I would say I used the better part of the tub.
Bryan