I have a set of hj61 axles that came with disc conversion on the back - dont think it was ever run. I was told fj60 calipers and rotor would work, but I am struggling to get the rotors mounted.
The hub has a slight bevel and while I can get the rotor on about 1/4 of the way, its not going any further. The rotors are from rockauto and I thought would be fine for rears, but am wondering if these might be slightly out of spec? they are c-tek rotors 121.44037.
I am reticent to trim the hub, especially since I don't know if these hubs are lug centric or not. I don't really want to buy another set of rotors unless I am sure they will fit.
Roughly, the diameter seems to be out by 1.5-2.5mm.
Thoughts?
The hub has a slight bevel and while I can get the rotor on about 1/4 of the way, its not going any further. The rotors are from rockauto and I thought would be fine for rears, but am wondering if these might be slightly out of spec? they are c-tek rotors 121.44037.
I am reticent to trim the hub, especially since I don't know if these hubs are lug centric or not. I don't really want to buy another set of rotors unless I am sure they will fit.
Roughly, the diameter seems to be out by 1.5-2.5mm.
Thoughts?