Thank you. This was actually extremely helpful. I found the holes for the 2 vent window pivots, and 2 window stops. However, I still need assistance on the door strikes. I already mounted the left and right door strikes which look slightly different than the extra ones. The screw holes are a little closer together on the ones that I cannot account for. See photos. Any other ideas would be greatly appreciated. Photos of vent window pivot and door window stopper are also attached or reference. Thanks.Doors. Glass stops at the bottom inside door. That rubber bumper is also the same as an fj45 drivers seat bumpstop. The wing window pivot, and door catch /striker on tub by your arm
Well, that solves part of the mystery. Thank you! Now I just have to figure out the correct nomenclature and where to install. I assume that I have already installed the correct parts on the body because the holes lined up. Not sure if those are called door strikes or stoppers. The extra pieces will be either door stops or strikers and I will look when I get hoe at where those go on the doors themselves.. This Forum is a terrific resource.My bad... One is a striker and one is a stop.