Help! Nut not Coming off (1 Viewer)

[Rwhat]

Is that new stud fully threaded in the picture?

 

[ajax1]

Why not just go to Toyota and buy the right studs

 

[Rwhat]

Why not just go to Toyota and buy the right studs

Because of the really shiny gold coating.

 

[Golden Dragon]

I did. I picked up some from Toyota this afternoon.

 

[Rwhat]

Also, either you got some sort of thread locker or junk on your wheel stud or it’s stripped.

 

[Golden Dragon]

I did. I picked up some from Toyota this morning. Everything is back together except for the retaining pin

Also, either you got some sort of thread locker or junk on your wheel stud or it’s stripped.

It’s thread locker. Some kind of red loctite

 

[mudgudgeon]

I got the new hub studs but they are longer than the OEM studs. Will I have problems with these ones?

View attachment 2225002

View attachment 2225003

View attachment 2225004

What's going on with that wheel stud?

Threads look like they are in poor shape (regardless of thread lock).

I'd give serious consideration to putting in a full set of fresh wheel studs while you have the hubs off the truck.

 

[nukegoat]

What's going on with that wheel stud?

Threads look like they are in poor shape (regardless of thread lock).

I'd give serious consideration to putting in a full set of fresh wheel studs while you have the hubs off the truck.

Agreed. That wheel stud looks like someone treated it like a torque-to-yield-and-keep-torquing

 

[mudgudgeon]

Loctite has no business on wheel studs

 

[fjbj40]

Wheel studs do look stretched!

 

[Rwhat]

Probably thread locker from wheel spacers.

 

[bigredmachine]

your also going to want some new wheel studs and lug nuts

 

[80JDM]

As long as the cone washers are fully seated after torqueing the nut. By the looks of it those threads do not appear to extend into the hub deep enough for the cone washer to seat. Also the studs that I recently bought from Toyota do not look anything the new one you show (maybe I got old stock?). They look exactly like the studs from the factory. Below is what I purchased for my 91.
42323-60010 Washer, Cone (For Rear Axle Shaft)
90116-08325 Bolt, Stud (For Rear Axle Hub Rh)
90201-08042 WASHER
90170-08204 Nut (For Propeller Shaft)

 

[Golden Dragon]

your also going to want some new wheel studs and lug nuts

View attachment 2226393

The new studs look the same. I scrapped off the thread locker residue.

 

[Rwhat]

You gonna show us pictures of your spindles?

 

[Golden Dragon]

You gonna show us pictures of your spindles?

 

[bigredmachine]

The new studs look the same.

I personally wouldn't trust that stud as it looks like the threads got stripped off but your truck your call

 

[Golden Dragon]

I personally wouldn't trust that stud as it looks like the threads got stripped off but your truck your call

Thank you all for the help. I finally replaced ALL the studs.

 

[Malleus]

View attachment 2227718

View attachment 2227719

I think you need another jackstand...just sayin'.

 

[Golden Dragon]

I think you need another jackstand...just sayin'.

hahaha. I had to use it to installed the Delta radius arms.