I have the Centering tool and measured and got the readings, but hit a snag.
Here are the numbers I got if someone can help explain I would greatly appreciate it.
A= 167.5mm
B= 165.0mm
C= 2.5mm
D= 1.6mm
after this is where I have problems
E should be "D" minus 3mm and this is the lower shim thickness; but this is going the be a negative number so what do I do at this point?
And the upper shim is C-E ; once again a negative would be in there. How is that dealt with?
Any help would be great
thanks
David
Here are the numbers I got if someone can help explain I would greatly appreciate it.
A= 167.5mm
B= 165.0mm
C= 2.5mm
D= 1.6mm
after this is where I have problems
E should be "D" minus 3mm and this is the lower shim thickness; but this is going the be a negative number so what do I do at this point?
And the upper shim is C-E ; once again a negative would be in there. How is that dealt with?
Any help would be great
thanks
David